UG NX二次开发源码分享：ＣＡＭ加工中获取加工时间

admin

' l  ^$ c6 A; `5 U7 U5 iUG NX二次开发源码分享：ＣＡＭ加工中获取加工时间

1. 
   
2.     CAM::CAMSetup *camSetup = displayPart->CAMSetup();
   
3.     CAM::OperationCollection *operColl = camSetup->CAMOperationCollection();
   0 B. s# A+ L6 G; C# O2 G
4.     CAM::OperationCollection::iterator it = operColl->begin();
   
5. 
   8 L- O2 g) O# \- w8 M% {3 R
6.     while( it != operColl->end() )
   : x3 N% B8 D. B# h( o6 s0 F
7.     {
   ! L0 R1 r' ?+ W7 M4 R0 g/ T" H
8.         CAM::Operation *oper = (CAM::Operation*)(*it);
   * L" a/ |* S9 b( `
9. 
   
10.         ostringstream out;
    
11.         out << oper->Name().GetText() << endl;
      \' ]2 G  C5 K6 e) z% Y& s
12.         out << " Toolpath Length: " << oper->GetToolpathLength() << endl;
    
13.         out << " Toolpath Time: " << oper->GetToolpathTime() << endl;
    
14.         out << " Toolpath Cutting Length: " << oper->GetToolpathCuttingLength() << endl;
    
15.         out << " Toolpath Cutting Time: " << oper->GetToolpathCuttingTime() << endl;
    ! ~. p& L9 I2 |8 ~7 P% ?! u& F
16. 
    
17.         print(out.str().c_str());
    
18.         it++;
    
19.     }

复制代码

6 T4 M$ e, F. I$ Y7 z* ^