NX12 废弃的建模功能，注意看看哦，开发能避免就避免了

mildcat

4 f& I1 ~  Q" J! T5 q( PCommands being retired in NX 12
The following commands have been dropped from the product line in NX 12 and are no longer
available:
! c" M: }4 U2 m• Emboss Sheet
• Move Defining Point
( J) b( ]6 S) p6 Q# }) G3 M+ q2 o• Move Pole
; @+ ]! K' L6 x/ s# }7 P8 U• Isoparametric Trim/Divide
8 j3 _8 A! S0 s$ ^6 N3 I& i
Commands to be retired in a future release of NX
6 X  w- J8 [( B, ^; {( IThe following commands will be retired in a future release of NX and are now hidden so that
- _4 ^0 V$ G, zCommand Finder will no longer list them.
/ D5 ^$ w$ s3 ?; o% W• Join Curve
% V, l# {5 J0 e( c- c$ G! U# O• StreTCh Curve
, w% I, @/ Y3 y1 M3 X• Fillet Sheet
• Spline—It is recommended to use Studio Spline or Fit Curve, Type = Fit Spline instead of the legacy Spline command.
/ N. y$ b3 F5 D1 `- T
% t: ^, T9 C6 c/ ^These commands are hidden in the menu bar menu and removed from any ribbon, toolbar, shortcut
1 R8 ?9 M% L0 @; V9 z9 c: Xmenu, and radial toolbar. Until they are retired, these commands can be broUGht back into NX using
& I. J( W3 {) X2 W* _8 V; D; Vthe Customize command, where they will appear with “(to be retired)” appended to their names.