NXOpen C++ CAM二次开发： 获取所有加工NC程序的时长

admin

: u: }/ ^/ E2 kNXOpen C++ CAM二次开发： 获取所有加工NC程序的时长
! ^( u) J* o: |  W7 O4 ]3 G

3 {* T7 g' t0 b+ D' J3 bvoid MyClass::do_it()
& i2 X2 @. j6 t5 t* d& y$ l2 Q{
! M  F9 g7 q. n
$ S4 r( Z6 ^$ ^% t  M: |- \
    CAM::CAMSetup *camSetup = displayPart->CAMSetup();
  A- t2 p. _' B( a6 c. A, E4 |    CAM::OperationCollection *operColl = camSetup->CAMOperationCollection();
$ \( ]) C+ E1 y5 b    CAM::OperationCollection::iterator it = operColl->begin();
: J& L3 i: M) k: _+ t! E  w* `
" X* t1 D% P9 c
    while( it != operColl->end() )
    {
        CAM::Operation *oper = (CAM::Operation*)(*it);


5 ^* b/ a9 o6 ?- e$ a0 W4 j        ostringstream out;
        out << oper->Name().GetText() << endl;
        out << " Toolpath Length: " << oper->GetToolpathLength() << endl;
        out << " Toolpath Time: " << oper->GetToolpathTime() << endl;
" F$ G6 b- G5 d5 Y- n1 |        out << " Toolpath Cutting Length: " << oper->GetToolpathCuttingLength() << endl;
0 T7 u+ c, E+ y3 ]        out << " Toolpath Cutting Time: " << oper->GetToolpathCuttingTime() << endl;
2 j9 K- q* m( v& q, _. u

6 l9 t6 ]' d4 T        print(out.str().c_str());
9 q* b% X1 p$ t  D( j. z        it++;
    }

) J/ T/ h; p# x; K, |
}
7 P7 F2 r: I- _6 }2 @+ V/ M( p" C